Payment & Shipping Terms:
|Product Name:||Methenolone Enanthate||Other Name:||Primobolan|
|Standard:||Enterprise Standard||Appearance:||White Crystalline Powder|
Primobolan Enanthate Methenolone Enanthate Steroids Dosage CAS 303-42-4
What is Primobolan?
Primobolan Depot is the injectable version of the steroid methenolone. It is the same compound as the one in Primobolan Orals (methenolone acetate). In this injectable version, an enanthate ester is added to the steroid, which makes for a slow and gradual release from the site of injection. Its length of activity would thus be quite similar to Testosterone enanthate, with blood levels remaining elevated for approximately two weeks. Methenolone itself is a long acting anabolic, with extremely low androgenic properties. It’s anabolic effect is also quite mild, its potency is considered to be slightly less than DecaDurabolin (nandrolone decanoate) on a milligram for milligram basis.
Primobolan is most commonly used during cutting cycles when a mass increase is not the main goal. Some athletes do prefer to combine a mild anabolic like “Primo” with bulking drugs such as Dianabol, Anadrol, or testosterone however, presumably to lower the overall androgen dosage and minimize uncomfortable side effects. When choosing between Primobolan versions, the injectable is preferred over the oral, as it is much more cost effective.
It is most popular for male bodybuilders to stack Primobolan with other steroids in order to obtain a faster and more enhanced effect. During a dieting or cutting phase, a non-aromatizing androgen like Halotestin or trenbolone can be added. The strong androgenic component should help to bring about an added density and hardness to the muscles. On the other hand we could add Winstrol, another mild anabolic steroid. The result of this combination should again be a notable increase of muscle mass and hardness, but in this case the gain should not be accompanied by greatly increased side effects.
Primobolan Depot is also used effectively during bulking phases of training. The addition of testosterone, Dianabol or Anadrol would prove quite effective for adding new muscle mass. Of course we would have to deal with estrogenic side effects, but in such cases Primobolan should allow the user to take a much lower dosage of the more “toxic” drug and still receive acceptable results.
a classic beginner cycle is 400 mg/week Primobolan as the only steroid used. Of course, this does not give extreme gains. But then again neither does 400 mg/week testosterone!
With most anabolic steroids or anabolic steroid stacks, total use needs to be at least 500 mg/week and more preferably 700-1000 mg/week before a cycle is likely to be highly effective. This rule is no different when Primobolan is used as the sole anabolic steroid or as part of a performance-enhancing stack.
|Testosterone Sustanon 250|
|Nandrolone Decanoate (DECA)||360-70-3|
|Trenbolone Acetate (Finaplix H/Revalor-H)||10161-34-9|
|Boldenone Undecylenate (Equipoise)||13103-34-9|
|Methandrostenolone (Dianabol, methandienone,Dbol)||72-63-9|
The half-life of methenolone enanthate is probably about 5 days. As a result, Primobolan is most effectively used when injected at least twice per week. At the 400 mg/week usage level, post-cycle therapy may be started only 5 days after the last injection, whereas at a higher level of usage such as 1000 mg/week, at least 10 days will be needed until recovery is likely to become possible.